Equip yourself with the recommended tools:
A pencil, a rule, a spirit level, a drill, a drill bit, a screwdriver.
You can download the assembly notice :
> assembly notice in pdf format
You must have theAdobe Acrobat Reader to open it
The pack contains
• The C-TOL storage furniture
• An assembly notice
• Two metal screws and two plastic wall plugs. Ensure that the screws and the wall plugs are suitable for the material and structure of your wall bracket
Take all necessary precautions when unpacking; avoid opening the box with a pointed or a sharp object, which could damage the wooden furniture.
(Please, refer to the diagram opposite)
• Draw a point A at 5 cm from the edge of your WC seat.
Attention! The height of point A is only given for indication and applies to a person measuring approximately 1m 80cm. The height of point A may be reduced or increased depending on the height of the persons who will use the CTOL furniture. Nevertheless, we advise you not to position it too low, in order to be able to access the toilet paper reel without difficulty.
• Draw a point B at 60 cm vertically from point A.
• Measure at the back of the C-TOL furniture the « interaxial », i.e. the distance between the 2 notches into which the screws will creep into when installed. Then, draw a point C from point B which is the « interaxial » of the 2 holes at the back of the furniture.
3/ Drill 1 hole on B and one hole on C using a drill bit suited to the selected wall plug and wall bracket.
4/ Insert the 2 wall plugs into the holes.
5/ Screw-down the 2 screws.The distance between the screw back flap and the wall bracket must be some 3 mm.
6/ Install your C-TOL furniture using the two appropriate notches.
7/ Use it! Order toilet paper rolls, cleaning products, magazines.
© C-TOL 2009 - General terms and conditions